MOLOMAX Pendular Mill

The MOLOMAX Pendular Mills are utilised to crush raw supplies of several kinds, specific weight and humidity appropriate as much as typical levels of hardness (clay, calcium carbonate, bentonite, chalk, dolomite and so on.) with incredibly high levels of production and exceptional quantities of fine material.

Thanks to the dual feeding system and the presence of precise internal plough-share distributors, loading inside the crushing chamber is optimised using a level of efficiency that is definitely considerably greater than similar types of mills.

Crushing is performed by massive pendulum that, under the action from the centrifuge power, apply enormous pressure for the track fitted within the base of the mill.

Once the material has been crushed it is actually transferred to the leading of the mill by the air that is definitely circulated by the fan or suction by a filter located in the bottom. The material is also classified by the separator configured at the bottom with the crushing process to be made.

Active handling with the feeding is combined with parameters identified in actual time by distinct procedure sensors, consequently automatically guaranteeing the highest level of efficiency in time.

Pendular Mill

In case of really abrasive raw supplies required for porcelain stoneware or when fired low water absorption tiles ,the Molomax oendualr mills are duly inner coated with Alubit.

MOLOMAX PENDULAR MILL -CYCLONE INSTALLATION

In the MS-CYCLONE pendular sort of mills, the solid-air separation procedure happens inside the cycle reduction collector. This can be placed in between the pendular mill as well as the fan, connected by a whole range of tubes: this program is also referred to as closed cycle.

This method is employed in special circumstances: by way of example in the presence of explosive supplies or materials with an electrostatic charge. Inside the case from the presence of raw supplies with a high percentage of humidity, this technique may possibly be integrated with a warm air generator.

MOLOMAX PENDULAR MILL - AIR INSTALLATION

In the MS-AIR kind pendulars, the crushed material is extracted and collected by a method filter, that subsequently downloads it towards the following stage of the engineering cycle. This kind of plant is also known as open cycle.

This approach makes it possible for for further optimisation of performance with the machine by increasing the final values of production, particularly within the presence of fine particles previously pre-treated. In MS-AIR pendular sort mills it really is also possible to insert hot gases into air veins with fantastic outcomes in terms of heat yield.

classifier equipment
grid ball mill
cone ball mill